The third is to offer sealing for coolant-through tools. Other lengths, medium and extra-long, available upon request. A secondary purpose of the adjusting screw is to assist the tool holder in keeping the cutter from being pushed up into the holder if the cutting loads increase to the point where the tool may slip up into the holder. Also available from stock in short and extended lengths. Available from stock in BT, Cat and HSK Tapers.Balanced to G 2.5 at up to 25,000 rpm, refer to charts for each taper size.Standard holders have 4.5° angle nose for compatibility with most heat shrink machines. (1) Stick Holder (2) Capto to Weldon Straight Shank Adapter.Coolant grooves and coolant porting also available. Direzione e Stabilimento: Via Provinciale, 15 - 23841 Annone di Brianza (LC) - P.IVA 01855200133. The interference fit between the ID of the toolholder and cutting tool shank forms the seal, preventing the coolant from flowing anywhere else except through the cutting tool. Allowing you to get parts out faster and with higher efficacy.
Our Capto Bolt-on Tool Blocks optimize your machine use by reducing set up and tool change time. Coolant through holders require no special backup screws or seals. Our newly designed Capto Static Bolt-On Tool Blocks bring a precise, rigid, and accurate quick-change solution to enhance production in the manufacturing environment.Low centrifugal Forces due to low holder mass. Coromant Capto as a modular system for machining centers offers a large variety of extension and reduction adapters, enabling the assembling of tools with different lengths and design characteristics regardless of the machine interface (SK, HSK, Big Plus). Improved balance design with no moving pieces.Tool is gripped 360°, along the entire length of the bore resulting in an evenly distributed clamping force and increased concentricity. Seller Contact: MARTY MECHTEL Phone: (612) 868-3466. Main Unit Dimensions (in inches): Length: 0.00' Width: 0.00' Height: 0.00' Seller Company: Lowell, Inc. The BIG CAPTO modular tooling system offers better efficiency, material selection, and heat treatment. Chip load distributed evenly along cutting edge of tool which results in longer tool life. Lot 69: (7) Capto C5 Tool Holders: (4) Insert Turning Tools and (3) Stick Tool Holders. The BIG CAPTO tool holder system is a dual contact modular turning and rotating system that strengthens the performance of machine tools.With proper use, toolholder life should exceed that of standard End Mill holders. Constructed with double tempered Tool Steel for exceptional durability and cycle life.The total time elapsed to remove one cutting tool and insert another is less than 10 seconds. The use of Heat Shrink Tooling allows for greater speeds and feeds, better finishes, increased tool life, and increased productivity due to its High Speed Machining capability and simplicity of use.HSK 100 SHRINKFIT HOLDER HIGH PRECISION TOOLHOLDINGįor Maximum Gripping Power with Exceptional Concentricity
0 kommentar(er)
